Sage X3 Java Bridge Server

Configuration

• Loading the Sage X3 Java Bridge Server component
• Configuration
• Solution publication

Loading the Sage X3 Java Bridge Server component

To load the Sage X3 Java Bridge Server component, activate the SAFE X3 Java Server left list and click on the Add button.

For more information on the component loading dialog box,click here...

The console acquires the various parameters of the component and loads it. Its parameters appear in the right-hand half of the page.

Note that the component status is "Idle". Once configured, this value will switch to "Active".

Configuration

To launch the actual configuration of the Sage X3 Java Bridge Server component, click on the Configure button.

On exiting the configuration, the component status is "Active", and the service on the host server is created and launched.

The Sage X3 Java Bridge Server is configured. It is now necessary to publish the solution.

Solution publication

To publish the solution, select the Publications tab of the SAFE X3 Java Server component .
Click on the button Add... and select the name of the solution to be published.

Update

To update the Sage X3 Java Bridge Server, follow the steps described below:

• Interrupt the services of the component via the console in the Administration tab of your Sage X3 Java Bridge Server. 
• Install the update (check out the installation procedures for further information) in order to replace your version with the new one.
• Refresh the configuration screen of your Sage X3 Java Bridge Server in the console. The update should automatically be detected by the console.
• Click on the configure button to complete the update.
• Verify that the services have been correctly restarted following the configuration.

Deconfiguration

To deconfigure the Sage X3 Java Bridge Server, follow the steps described below:

• Interrupt the services of the component via the console in the Administration tab of your Sage X3 Java Bridge Server. 
• Unpublish all the solutions.
• Click on the Deconfigure button.
• Uninstall your component on the server.