Additional X3 process server

Configuration

• Loading
• Configuration

Loading

To load an Additional process server component, click on the Add button, in the Process servers tab.

For more information on the component loading dialog box,click here...

The component status is "Idle", on exiting the configuration it becomes "Active".

Configuration

To configure the additional process server component, enter the mandatory parameters:

• SAFE X3 service user account: Name of the user account starting the SAFE X3 service (By default LocalSystem for Windows, and root for UNIX)
• Password of the user account: Password of this account
• DBMS client path (up until V6 version) ORACLE installation path. Make sure that the version of your DBMS corresponds at least to the version of your DBMS server.

To launch the actual configuration of the Additional process server component, click on the Configure button:

The service is going to be created on the port chosen for the main process server configuration. If this port is already taken on the Additional process server, the configuration cannot be carried out.

On exiting the configuration, the ADXD process of the additional process server is created and started. The component appears in the architecture on the left and in the list of process servers. Its status will become "Active".

The server can now be used. It is now possible, using this server, to connect to the application folders.

NB: After an additional process server has been added, an update of the publications can be necessary. In such a case, the solution must be published again for the Safe X3 Web Server, the Safe X3 Java Bridge Server or the Safe X3 Print Server.

Update

To update the additional process server, follow the steps described below:

• Stop the additional process server service via the console using the solution Process servers tab.
• Install the update (check out the installation procedures for further information) in order to replace your version with the new one.
• Refresh the solution configuration screen in the console. The update should automatically be detected by the console.
• Click on the configure button to complete the update.
• Check that the service has been correctly restarted following the configuration.

Deconfiguration

To deconfigure the additional process server, follow the steps described below:

• Stop the additional process server service via the console using the solution Process servers tab.
• Select from the list of process servers the additional process server to be deconfigured.
• Click on the Deconfigure button.
• Uninstall your component on the server.