Mandatory reconciliation
This setup is used in the Optimization function of the Manufacturing module.
It can be used to specify whether the weighing reconciliation is mandatory or not before the commitment.
- Yes: the "Commit to manufacturing" function prohibits the validation if the reconciliation step has not been carried out.
- No: the "Commit to manufacturing" function enables the validation even if the reconciliation step has not been carried out.
Level of localization/Global variable
This parameter is defined at the level Site. It belongs to Chapter GPA (Manufacturing) and the Group WEI (Weighing stations), The following parameters are also associated with this chapter and group :
- ALLAUT (Automatic allocations)
- APTOPW (Apply tolerance)
- CUTCAB (BC division upon recheck)
- CUVCTL (Tank recontrol (mfg weighing))
- ENGAGE (Committed to mfg)
- ITMCTL (Re-check product (weighing))
- LENLOT (No. characters for comparison)
- LISMAT (Material list loading)
- POSTOL (Tolerance+ exceeded)
- PRIALL (Allocation priority)
- PRTWEI (Partial weighing)
- RECONCIL (Reconciliation)
- REDNEG (Negative adjustment)
- SELWGG (Selection of weighings)
- UPDSTO (Update stock line)
- USRWEI (Weighing user control)
- WEICOMSEQC (Weighing component seq ctrl)
- WEIRPTALL (Allocation report code)
- WEIRPTETI (Weighing label report code)
- WEIRPTOF (End of WO report code)
- WEIRPTOPE (End of operation report code)
- WEITRSNUM (Weighed material tracking trans.)
- WEIVT (VT entry mode)
The global variable GRECONOBLI is associated with it.
Functions concerned
The following functions are associated with this parameter :
Manufacturing > Weighing > Commit to manufacturing
Activity codes
The following activity codes (sorted by type) are associated with the parameter :
MWM :
Weighing stations