Financial asset numbering
Use this parameter to determine how the Reference is assigned when creating a fixed asset.
Select from one of the values listed below:
None - You need enter the Reference manually when you create the asset. Automatic numbering is not active.
Mandatory - The Reference is automatically assigned on validation and cannot be modified.
Optional - By default, the Reference is automatically assigned, but you can modify it.
Level of localization / Global variable
This parameter is defined at the level Company. It belongs to Chapter AAS (Fixed assets) and the Group FAS (Fixed assets), The following parameters are also associated with this chapter and group :
- CPLDURMIN (Add. asset minimum duration)
- CPLDURPRC (Add. asset % depre dur)
- CPYTAXRUL (Taxation rule)
- CREDIRFAS (Assets: direct creation)
- CREDIRLOF (Expense: direct creation)
- DEFUOM (Default unit)
- DEROENCOUR (Book vs tax on FA in process)
- GCMPMAX (Max no. of component assets)
- IMLNSPNBV (Impair if Market value > NV)
- IMLRVEISS (Disposal: impairment loss reversal)
- LOFAUTNUM (Expense numbering)
- LOFIASAMT (IAS amt entry expense cap)
- LVALIM (Low value asset threshold)
- LVAMSG (LVA Single message)
- NBEXESTO (Number of FYs to be stored)
- NBEXNOHIS (No. closed FY to be saved)
- POOLIM (Asset pooling threshold)
- PPLAUTNUM (Production plan numbering)
- PRVSITUPD (Previous situation mod)
- SALINV (Sales invoice to generate)
- STKISSACC (Accounting code line index)
- WIPDEP (Free plan WIP depreciation)
The global variable GAASAUTNUM is associated with it.
Functions concerned
The following functions are associated with this parameter :
Fixed assets > Fixed assets > Assets
When creating an asset, this parameter value also applies to the Reference when you Capitalize an asset and if you Split an asset.
Comments
To use automatic numbering when you create an asset, you need to have set up a sequence number counter. This is done in the Structures (GESANM) and Assignments (GESTCA) functions, which are located under the Setup > General parameters > Sequence number definition menu.